Assembly of Latex Mattress

Assemble Your Mattress in 15 Minutes. Watch Our Video Tutorial for More Info.

1.

1.

When UPS delivers your new mattress it will consist of either three or four boxes depending on the size of the mattress you ordered from Sleep EZ

2.

2.

Transport boxes to the bedroom where the mattress will be used. Assemble mattress on top of your existing box spring or foundation. Avoid assembling on floor and then moving to foundation. Even though each component is not heavy a fully assembled king weighs around 140 pounds

3.

3.

Locate the box containg mattress cover.

4.

4.

Empty the box and make a small cut in the plastic . Importgant Note: keep your shipping boxes in case you need to swap out a layer

5.

5.

Tear off outer clear plastic sleeve. Cut black plastic and gently tear it open.

6.

6.

Cover will be packed inside latex layer. Remove cover and place on foundation with quilted side up.

7.

7.

Unzip cover and lay it on foundation with the label at the foot of the bed. This will allow you to fold the top panel out of the way at the head of foundation

8.

8.

Now you're going to invert the bottom of the cover over the foundation (much like you would a fitted sheet) so the sides of the cover are ot of the way when you lay down your latex layers.Pull four corners down over foundation.

9.

9.

Fold top panel out of the way to make stacking your individual layers easier

10.

10.

Begin stacking latex layers from the bottom up. If your bottom layer is Firm, open the box containing this layer and place it on top of foundation. Cut and remove black plastic and roll latex layer into place.

11.

11.

All layers will be marked with firmness

12.

12.

Position and adjust as you put layers in place. Do not pull the latex as you will tear or stretch it--rather lift the latex up with both hands to reposition it then lay it down.

13.

13.

Do the same for the other side if you have ordered split layers for his and her sides.

14.

14.

Continue stacking the next layers. Remember to "lift and lay down" the latex without pulling or stretching it.

15.

15.

When all layers are in place you're ready to lift the four corners of the cover over the latex layers, fold down the top of the cover and zip up the mattress.

16.

16.

Pull up one corner at a time inserting your hand inside the cover to guide the latex into the corner of the cover so the corner is smooth.

17.

17.

Corner adjustment with both hands. Latex layers have a strong "natural grab" due to their texture-so each layer holds the others in place

18.

18.

Place the top "mattress" panel over the latex layers. Gently push down on the latex layers as you zip the cover closed.

19.

19.

As you zip the mattress tuck the attached flap down on the inside of the mattress.

20.

20.

Move around the mattress tucking and zipping at the same time.

21.

21.

Your assembly is complete with Sleep EZ label at foot of mattress.

22.

22.

Our bedtime advice before you begin sleeping on your new mattress is this: Your body will generally need some time to adjust to this new feel. ( Please take a monent to read what to expect when adjusting to the feel of latex) Click Here